Skip to content
IDAHO
CATTLE GUARDS

Treasure Valley · Magic Valley · Eastern Idaho

Cattle guards, delivered or installed.

12 to 24 ft, flat rail or pipe, with or without wings, plus ranch gates. Buy the guard on its own and set it yourself, or we source the right one and line up the crew to put it in the ground.

Tell us the opening and what crosses it. We will tell you what it takes - including when you need less than you thought.

Takes a minute, and there is no obligation.

Cattle guard cross-sectionSide section through a cattle guard: rails spanning two concrete abutments over an excavated pit, with a gravel cleanout below and the roadway on each side.OPENING WIDTHRAILS + SPACINGABUTMENTGRAVEL CLEANOUT
Cross-section of a concrete-abutment install. Schematic: rail size and spacing come from the manufacturer's spec sheet.

Two ways to buy

Pick the one that fits your weekend

Option one

Guard only

You have a tractor and a weekend.

  • We size it with you and price it
  • Pickup, or delivery inside our service area
  • Manufacturer spec sheet and load rating come with it
  • Excavation and base are yours
Price the guard only

Option two · most people

Guard, installed

You want to drive over it, not organise it.

  • Everything above, plus
  • Site review before anyone quotes a base
  • Excavation, base, setting, wings, fence tie-in
  • a local crew we line up for you, booked for a day that works
  • The gate, where a public road requires one
Get my free quote

Several crossings

Bulk and agency quotes

Counties, highway districts, the BLM, the Forest Service, the Idaho Department of Lands, contractors and developers. Itemised by crossing, with a formal bid, a PO or tax-exempt paperwork if that is what your process needs.

Request a bid

Takes a minute, and there is no obligation.

What we do

  • Size the crossing. Width and load class for the traffic that actually uses it, not the average.
  • Supply the guard. From a partner manufacturer, with its specification and load rating documentation.
  • Deliver it. Inside the Treasure Valley, Magic Valley and Eastern Idaho.
  • Arrange the install. We line up the crew, agree the base, and keep it one conversation.
  • Walk you through approvals. Who has to consent on a public road, and what the statute asks for alongside the guard.
  • Supply and hang ranch gates. Including the 12 ft gate Idaho law requires beside a public-road crossing.

What we are not

  • Not a manufacturer. We do not fabricate guards and we do not certify load ratings - the manufacturer does, and you get their document.
  • Not a construction company. We arrange the crew; we do not employ them.
  • Not a fencing contractor. We tie into your fence at the crossing. We will not quote you a mile of it.
  • Not an engineer. If your crossing needs a stamped design, we will say so and you will need one.
  • Not able to promise an approval. Nobody can. We help you through the steps; the road authority decides.

If what you need is outside that list we will tell you on the first call rather than three weeks in.

One contact, not a lead farm

Your request comes to us. We do not sell your details to a list of contractors who all ring you at dinner.

The documents, not our word

Load ratings come as the manufacturer's certificate. Nobody should take a rating on trust from a website, including ours.

No price we have not set

You will not find an invented range on this site. You get a number for your opening, with what it covers spelled out.

How it works

Three steps, then you drive over it

  1. Tell us the opening. Rough width, what crosses it, and whose road it is. Two photos from 20 ft back help a lot.
  2. We price it. Guard only, or guard with a crew lined up and the base agreed after someone has looked at the ground.
  3. It arrives, or it gets set. Delivered to your yard, or excavated, based, set, winged and tied into your fence.

What each install step involves

The four install steps, and the job from quote to installStep one, excavate the opening. Step two, build and compact the base. Step three, set the guard and check it level. Step four, fit wings and tie into the fence. Below, the job runs quote, site review, delivery, install.1EXCAVATE2BASE3SET + LEVEL4WINGS + FENCEQUOTESITE REVIEWDELIVERYINSTALL
Base prep is most of the job. A guard set on disturbed ground settles, and a settled guard stops draining.
Cattle guard load classesFour load classes as bars of increasing length: ATV and UTV crossings, private and ranch use, heavy ranch and farm equipment, and highway rated. Only a highway rating is accepted on a public road.ATV / UTV CROSSINGPRIVATE / RANCH USEHEAVY RANCH + FARM EQUIPMENTHIGHWAY RATEDAXLE LOAD AND USE INTENSITY →PUBLIC ROADS
A public road needs a highway rating, and only the manufacturer can certify one. We send you the certificate with the quote.

Getting it right the first time

The rating has to match the road

A guard rated for a ranch lane and a guard rated for a county road are different steel at different prices, and the difference is not visible from the top. A public road needs a highway rating - and only the manufacturer can certify one, which is why we send you the certificate rather than our opinion.

The other half is width: measure the surface traffic actually uses, at the widest point, then go wider. Most Idaho ranch roads end up at 16 ft.

Before you order anything

Measure the road, not the gate posts

The gap between your gate posts is not the number that matters. Measure the travelled surface at its widest point, then allow for the trailer that turns in off the county road at an angle. Get this wrong by two feet and you have a guard with a wheel hanging off the end of it.

Send a photo and a rough figure and we will check it with you before anything is ordered.

Measuring the opening for a cattle guardLooking down on a road between two fence lines. The travelled surface is measured first, then the guard is sized wider than it so equipment does not run off the end of the rails.GUARD WIDTHTRAVELLED SURFACESHOULDER EACH SIDEMEASURE THE SURFACE EQUIPMENT USES, NOT THE GAP BETWEEN POSTS
Measure the surface traffic actually uses, at the widest point, then size the guard wider than it. How much wider depends on what turns in - we settle it at the site review.
Where we deliver and installA schematic outline of Idaho marking the three regions we serve: the Treasure Valley in the southwest, the Magic Valley in south-central Idaho, and Eastern Idaho.TREASUREVALLEYMAGIC VALLEYEASTERNIDAHO
Schematic, not a boundary map. We cover all three regions.

Where we deliver and install

31 Idaho counties, three regions

Treasure Valley — Ada, Canyon, Gem, Payette, Owyhee, Boise, Washington

Magic Valley — Twin Falls, Jerome, Gooding, Lincoln, Minidoka, Cassia, Blaine, Camas

Eastern Idaho — Bonneville, Bingham, Madison, Jefferson, Fremont, Bannock, Power, Teton, Butte, Clark, Caribou, Franklin, Bear Lake, Oneida, Custer, Lemhi

Outside these counties? Ask anyway. For a project of a few crossings we will usually make the drive, and we will tell you plainly if we are not the right people.

Straight answers

Can I just buy the cattle guard without the install?
Yes, and it is a normal thing to want. Pick it up or we deliver inside our service area, and the base prep is yours. Tell us the width and the load class and we will price it. Buy the guard only.
What does a cattle guard cost in Idaho?
Width, load class, wings and base type decide most of it, then the ground decides the rest. We do not publish prices we have not set - ask and you get a real number for your opening rather than a range that moves when you call. What moves the price.
Do I need permission to put one on my road?
On a public road, yes: Idaho Code 40-2310 needs the consent of the county commissioners, the highway district commissioners or whoever else governs that road, plus an unlocked gate at least 12 ft long within 33 ft of the highway. State highways go through the Idaho Transportation Department instead. The rules, cited.
What width do I need?
Measure the surface traffic actually uses, at the widest point, then go wider than that. Most Idaho ranch roads land on 16 ft; rural driveways are often 12 or 14 ft. Sizes and widths.
Who actually does the installing?
We supply the guard and line up a local crew to set it. We are not a construction company and we do not employ the crew - what we do is make it one conversation instead of two: the right product, delivered, with a crew booked for a day that works.
Are cattle guards safe for horses?
Treat a standard cattle guard as unsuitable for horse traffic. A hoof can go through the rails and the injuries are severe. Use a gate for horses unless a manufacturer documents a design specifically for them.

Tell us about the opening and we will size it

Width, what crosses it, and whether the road is public or private is enough to start. If you only want the steel, say so on the form and that is what you will get a price for.

Get my free quote