Skip to content
IDAHO
CATTLE GUARDS

Idaho rules

Who has to say yes to a cattle guard

On a public road in Idaho, a cattle guard needs the consent of whoever governs that road - the county commissioners, the highway district commissioners, or another governing body - and the connected fence must carry an unlocked gate at least 12 ft long within 33 ft of the highway. State highways are excluded from that section and go through the Idaho Transportation Department instead.

The short version

Public road
Consent required from the governing road authority.
The gate
At least 12 ft long, within 33 ft of the highway, unlocked at all times.
State highway
Not covered by 40-2310 - ITD encroachment permit instead.
Private drive
Usually no road-authority consent, but check county, HOA and easement rules.
Federal or state land
Agency specifications and authorisations apply.
Last reviewed
2026-11-18

Cattle guards across public roads in Idaho

State of Idaho - counties and highway districts

A landowner whose land is fenced by a lawful fence may build a cattle guard across a public road only with the consent of the county commissioners, the highway district commissioners, or whoever else governs that road - and the connected fence must carry an unlocked gate at least 12 feet long within 33 feet of the highway.

The statute is headed “Cattle guards across roads — Landowner’s right to construct — Gates”, and it was added in 1985 (1985 ch. 253 § 2). Three things in it decide how a crossing on a public road goes.

You need consent, from whoever governs that road. The statute names the commissioners, the highway district commissioners, “or other” governing body with jurisdiction over the road. In Idaho that is not always the county: roughly 65 independent highway districts administer roads in their own right, and which body governs your road is a question of fact, not of address. Ask the county first; they will tell you if a highway district has it.

The fence must carry a gate, and the gate has rules. Not less than 12 feet long, not more than 33 feet from the highway, and unlocked at all times. The gate is part of the requirement, not an upsell - a cattle guard with no gate beside it does not satisfy the statute, and a locked gate does not either. Someone has to be able to get stock, a trailer or a wide implement through without the guard.

State highways are excluded. The statute applies to “any highway, except highways maintained by the department” - the Idaho Transportation Department. If your access is onto a state highway, this section is not the process you are in; see the ITD rule below.

Source: Idaho Code 40-2310 (statute), retrieved 2026-11-18. Last reviewed 2026-11-18.

Crossings on a state highway go through ITD

Idaho Transportation Department

Idaho Code 40-2310 does not apply to highways maintained by the Idaho Transportation Department. Work in state highway right-of-way - including a new or changed approach - needs a right-of-way encroachment permit from ITD under IDAPA 39.03.42.

If your gate opens onto a state highway, the county consent process is not the one you are in. The cattle guard statute explicitly excludes highways maintained by the department, and ITD runs its own permitting under IDAPA 39.03.42.

What the rule covers is broader than a cattle guard: a permit is required for any use of state highway right-of-way other than normal travel, which includes adding a new approach, and changing the use, width or location of an existing one. ITD publishes an online Right of Way Permit Tool that walks through the application, and the applications are reviewed against access control requirements, deed restrictions, safety and capacity, design and location standards, environmental impacts and long-range planning.

Start here: ITD Right of Way Services.

Two practical notes. The rule states that no work may happen in state right-of-way until a permit has been issued by the department or a delegated local highway agency - so this is a step that comes before the dig, not alongside it. And published ITD permit guidance asks for prepayment and allows 30 business days for processing, which in practice makes the permit, not the steel, the long pole in the schedule.

[VERIFY] Whether a cattle guard at an existing permitted approach needs a new permit, or an amendment to the existing one, depends on the approach and is a question for the ITD district office that covers your highway. We help you ask it; we cannot answer it for your location, and nobody should guess at it in writing.

Source: IDAPA 39.03.42, Rules Governing Highway Right-of-Way Encroachments on State Rights-of-Way (administrative-rule), retrieved 2026-11-18. Last reviewed 2026-11-18.

Plan view: cattle guard, wings, fence tie-in and gateLooking down on a crossing. The guard sits in the road opening, wings flare out to meet the fence on each side, and a gate at least twelve feet long sits in the fence line within thirty-three feet of the highway.WINGSGUARD IN THE OPENINGGATE, 12 FT MINIMUMFENCE TIE-INROAD
On a public road, Idaho Code 40-2310 requires a gate at least 12 ft long in the connected fence, within 33 ft of the highway, kept unlocked.

What compliance looks like on the ground

The guard sits in the opening. The fence comes to the wings so stock cannot walk around the ends. And beside it, in the connected fence, there is a gate - at least 12 ft, within 33 ft of the highway, and not locked. That gate is how stock, a wide implement or anyone who needs to get through does it without using the guard.

We supply and hang that gate as part of a public-road install, because leaving it to the owner is leaving the statute half done.

Finding your road authority

Idaho splits road jurisdiction between counties, independent highway districts, cities and the state. Which one governs the road at your gate is a question of fact, and getting it wrong means a request sitting on the wrong desk.

  1. Call the county. They will tell you if a highway district has your road.
  2. If a district does, go to that district - the Idaho Association of Highway Districts directory lists member districts.
  3. If the road is a state highway, start with ITD Right of Way Services.

External links retrieved 2026-11-18. We are not affiliated with any of these bodies.

Ranch gate elevation with the 12 foot minimumA tubular ranch gate hung between two posts, with a dimension line showing the twelve foot minimum length Idaho Code 40-2310 requires in the fence beside a public-road cattle guard.12 FT MINIMUMUNLOCKED AT ALL TIMES
Beside a cattle guard on a public road, Idaho Code 40-2310 requires a gate at least 12 ft long, within 33 ft of the highway, kept unlocked.

Questions we get asked

Do I need permission to install a cattle guard in Idaho?
On a public road, yes. Idaho Code 40-2310 lets a landowner or lessee whose land is fenced by a lawful fence build a cattle guard across a highway only with the consent of the county commissioners, the highway district commissioners, or the other body governing that road. On a private road or driveway you generally do not need that consent, though county, HOA, easement and right-of-way rules can still apply.
What gate does the law require?
A gate not less than 12 feet long in the connected fence, not more than 33 feet from the highway, kept unlocked at all times. The gate is part of the requirement, not an optional extra - and a locked gate does not satisfy it.
Does this apply to state highways?
No. Section 40-2310 applies to any highway except highways maintained by the Idaho Transportation Department. For a state highway you are in ITD’s right-of-way encroachment process under IDAPA 39.03.42 instead.
How do I find out whether a county or a highway district governs my road?
Ask the county first; they will tell you if an independent highway district has jurisdiction. Idaho has roughly 65 highway districts administering roads in their own right, so the answer is not predictable from your address.
How long does approval take?
That is the authority’s timeline, not ours, and it varies. Published ITD guidance asks for 30 business days on a right-of-way permit. Plan on the approval, not the steel, setting your schedule.
What about BLM, Forest Service or state endowment land?
Agency specifications and authorisations apply, and they are specific to the agency and the allotment or lease. We will not claim a product meets an agency specification without the manufacturer document that says so for that product.
Get my free quote